木粉疏水改性对HDPE基木塑复合材料性能的影响

采用一种操作简便且易于工业推广的方法对木粉进行疏水改性，具体过程为：将3种可热聚合的单体，即甲基丙烯酸甲酯（MMA）、甲基丙烯酸丁酯（BMA）和苯乙烯（St）均匀喷洒在木粉上，经过预热处理后，与配方中其他组分，如高密度聚乙烯（HDPE）和马来酸酐接枝聚乙烯（MAPE）等通过高速混合机混合均匀，采用双螺杆挤出机造粒后，注射制备木塑复合材料（WPC）样条，测试其力学性能。另外，考察了疏水改性对WPC接触角、维卡软化温度、洛氏硬度、吸水性能、热性能的影响规律。结果表明：疏水改性后WPC的接触角增大，木粉和HDPE的界面相容性改善，力学性能得到明显提高。其中，当MMA、BMA和St的添加量为3%时，WPC的力学性能最好，与疏水改性前相比，弯曲强度分别提高了17.3%、26.3%和27.5%，弯曲模量分别提高了24.4%、24.4%和26.0%，冲击强度分别提高了54.7%、57.7%和60.5%。 此外，疏水改性后WPC的维卡软化温度、洛氏硬度、耐水性和耐热性也得到改善。     

离子交换水软化技术研究与应用进展

离子交换法是目前最常见的水软化技术之一，其基于可逆的离子交换反应将溶液中的硬度离子选择性去除，属于典型的特种分离过程。本文介绍并总结了离子交换水软化的基本原理、水软化用离子交换树脂的结构和分类、离子交换水软化技术研究和应用，并针对离子交换水软化存在的问题提出了相应的解决思路。     

Vertical cyclic loading response of geosynthetic-encased stone column in soft clay

Dynamic responses of the geosynthetic-encased stone column (GESC) supported embankment under traffic loads have become a hot topic. This study investigates the responses of GESC improved ground under vertical cyclic loading. A series of laboratory tests in a designed model test tank have been carried out with different loading parameters (varied loading amplitudes and frequencies), different column dimensions (varied encasement lengths and column diameters). In the tests, the soil-column stress distribution, accumulated settlement of loading plate, excess pore water pressure in the surrounding soil and lateral bulging of the stone column are monitored. Experimental results indicate that the vertical stress on the stone column increases with the increment of encasement length, and decreases with the increment of column diameter, loading amplitude and loading frequency. The increasing stress on the surrounding soil leads to a greater accumulated settlement of the loading plate and excess pore water pressure, while the increasing stress on the column leads to larger lateral bulging of the column. Excess pore water pressure dissipates effectively through vertical and horizontal drainage channels provided by the stone column and the sand bed. The geosynthetic encasement prevents the clay from obstructing the drainage channel by filtration and guarantees the drainage effect.     

Migration and distribution of saline ions in bauxite residue during water leaching

Bauxite residue, a highly saline solid waste produced from digestion of bauxite for alumina production, is hazardous to the environment and restricts vegetation establishment in bauxite residue disposal areas. A novel water leaching process proposed here was used to investigate the dynamic migration and vertical distribution of saline ions in bauxite residue. The results show that water leaching significantly reduced the salinity of bauxite residue, leaching both saline cations Na⁺, K⁺, Ca²⁺ and anions CO^2?₃, SO^2?₄, HCO^?₃. Na⁺ and K⁺ migrated from 40–50 to 20–30 cm of the column, presenting a high migration capacity. The migration capacity of Ca²⁺ was lower and accumulated at 30–40 cm of the column. CO^2?₃ initially distributed at 20–30 cm of the column, subsequently transported to 30–40 cm of the column, and finally returned to 20–30 cm of the column along with evaporation. SO^2?₄ was originally distributed at 40–50 cm, but finally migrated to 20–30 cm of the column. Nevertheless, HCO^?₃ remained at the bottom of the column, and its migratory was less affected by evaporation.     

水位骤降对下伏隧道堤防安全影响研究

建立了考虑水位骤降条件下的下伏隧道堤防模型,依托湘江某下伏隧道堤防工程,基于堤防边坡渗流原理,结合有限元应力计算,探讨了不同水位骤降速率下的浸润线情况,计算了堤防安全系数。研究结果表明:湘江水位骤降速率越快,浸润线变化范围越大,浸润线变化范围与水位降落速率成正比;湘江水位骤降速度在3 m/d^4 m/d,水位降到28.8 m时,堤岸失去稳定;水位骤降并非整个过程中堤岸均处于失稳状态,而是水位降至某高度后堤岸失稳,骤降速率增快对堤防安全系数有一定负面作用。研究结果对隧道下穿堤防建设具有一定指导意义。     

Microstructural,hydraulic conductivity and geochemical changes of drying mature fine oil sand tailings in column experiments

This study offers new insights into two-lift deposition of mature fine tailings under atmospheric drying. The interaction of newly added lift and former lift(s) was evaluated using column experiments in terms of volumetric water content, electrical conductivity (EC), hydraulic conductivity, geochemistry and microstructure. Water content and EC followed the same trend and decreasing of water content appears to be responsible for significant reduction in EC. Evaporation on top of the column reduced the water content to almost zero. The obtained results support the coupling between the hydraulic and chemical processes that should be considered by active operators.     

New batch and continuous systems for converting hydrogen from water hyacinth

Water hyacinth was the chosen alternative biomass for H₂ production in this study. A batch and a continuous pilot plant systems are proposed. A batch system of 500?ml capacity was developed first for finding an appropriate biomass ratio which was found to be 2.5%wt. Results from the batch system was used to construct a kinetic model of water hyacinth hydrolysis. The same biomass and water ratio was used in the continuous system. Besides water hyacinth, glucose and cellulose?+?lignin biomasses were tested. During processing, temperature, pressure, and electric consumption of the system were recorded. The quality and quantity of gas products were analyzed by gas chromatography (GC). The water hyacinth biomass attained the highest rate of H₂ production (providing energy of 11.43?kWh/mole of glucose). Comparing the batch and continuous pilot systems, the continuous system achieved 2.7 times more H₂ mole% than the batch system did.     

Activated Carbon Supported CaO from Waste Shells as a Catalyst for Biodiesel Production

In the wake of increasing environmental constraints, this work is aimed at developing a catalyst purely prepared from waste biomass source as the raw material. The catalyst is investigated for its applicability in transesterification of vegetable oil with the objectives: (i) to use waste shells of mollusk as raw material for the preparation of activated carbon and CaO; (ii) to use it as heterogeneous catalyst in the transesterification of waste cooking oil; (iii) to optimize the different parameters affecting the transesterification reaction; and (iv) to study its reusability. Under optimized conditions it was observed that a conversion >90% was possible and the catalyst could be reused five times with a slight loss in activity. This study indicates that the biomass source could also be used as a potential raw material in the synthesis of environmentally benign catalysts.